We have 4 guests online
Project Datasheets
The following datasheest contain a summary and selected screenshots from a selection of projects undertaken by Granite Productions over the last few years. Please contact us if you would like further information about any of the project featured here.
DocumentsDate added
 |
The Atlantic and Cromarty Field Development drilled one production gas well at Cromarty and two wells at Atlantic. The fields export gas to St Fergus via an 80km pipeline. |
 |
The Maria field is located in UKCS Block 1629a in the Central North Sea approximately 250 km to the east of Aberdeen and 11 km North-West of the Armada platform. Maria is produced by means of a subsea production tie-back to the Armada platform. Two wells were drilled, one in the Maria Terrace prospect and one in the adjacent Maria Horst prospect with adjacent tophole locations. |
 |
The Miskar Gas Field is located in the Gulf of Gabes 122 km off the coast of Tunisia. The field came on stream in 1996. The produced gas and condensate are produced via a 125 km, 24" pipeline to the Hannibal production facility 21 km south of Sfax. In order to maintain production levels, infill wells were planned for the Miskar Field. Two additional wells were drilled approximately 2.8 km South of the Miskar Platform using subsea completions and tied back to the Miskar A platform via subsea flowlines. A further four wells will be drilled from the Miskar A Drilling & Production Platform. |
 |
The NW Seymour field is located in UKCS Block 22/5b in the Central North Sea approximately 250 km to the east of Aberdeen and 2 km east of the Armada platform. SW Seymour is in production by a development well drilled from the Armada latform. NW Seymour will be tied back to and produced from the Armada Platform. |
Granite Production Flysheets - CMYK TIFF 300dpi
 |
High level Visual Communication, Presentation and 3D Visualisation. For Engineering, Marketing, Product Development and Project Support. |
| |
High level Visual Communication, Presentation and 3D Visualisation. For Engineering, Marketing, Product Development and Project Support. Collection of Datasheets listed below. |
 |
This presentation describes the replacement and bypass of the Cell Import/Export Manifolds and 10 Cell Fill Lines located in the Utility Shaft of the Brent Bravo platform. The construction activity installs a new Import/Export Manifold at EL +87m, above the existing equipment at the Cell Fill Manifold level. |
 |
The objective of the Brent Bravo Minicell Project’s first periodic inspection was to inspect the cell-fill oil lines, ballast water systems and redundant systems in the Minicell and Utilities Shaft below +76m to ensure that their integrity is maintained for the remaining operational life of the platform. This presentation provided an introduction to issues relating to Access and Inspection of the Utility Leg Minicell Structure and Pipework located in the Utility Leg of the Brent Bravo Platform. |
 |
The purpose of inspection of Brent charlie C4 Leg below the Gas Tight Floor was to prove the integrity of the identified lines. General Visual Inspection was also undertaken on the concrete Cell Structure and the Support Steel Structure. |
 |
As part of the Long Term Field Development (LTFD) plan a Fuel Gas Import (FGI) system was installed on Brent Bravo, Charlie and Delta. This system provides sufficient fuel gas to re-start the process following a production shutdown, utilising gas from the gas export pipeline. |
 |
As part of the Brent Low Pressure Operation Plus (LPOP), the RB211 Turbine driven HP Compressor was replaced. The existing 6 wheel compressor assembly was replaced with an 8 wheel compressor assembly, satisfying conditions of lower suction pressure whilst maintaining discharge pressure. |
 |
The MOPUP project provides robust and fit for purpose oil export facilities for the Brent field through to Cessation of Production. M1W Workscope replaced 1 x 100% Electrical MOL Pumps (with spare on the beach). The C4 Workscope replaced 2 x 50% Electrical Booster Pumps (with spare on the beach). |
 |
The Cormorant A Booster Pump Replacement Project undertook the replacement of Isolation Valves VB-133, VB-135, HCV3 266 and HCV-3267 and associated Pipework below the Oil Booster Pumps CA-P3 200, CA-P-3210 and CA-P3 220 in Leg C4. |
 |
As part of the Dunlin A- Leg Integrity Management programme, all Recoverable and Attic Oil stored in the platform Storage Cells was exported. The existing Import/Export system were decommissioned and the Import/Export Lines and Storage Cells were sealed. |
 |
The Howe Project involved the brownfield installation of facilities on the Nelson platform including; 6 Production Line, CantileverSupport Platform, 3 Gas Line, ESDV and Riser Installation, Subsea Control Systems, Chemical/Methanol Injection and Allocation Metering. |
 |
The Nelson Oil to Sea Project was part of a major Environmental Project to reduce the volume of Produced Oil discharged to Sea. In compliance with OSPAR regulations, Produced Water will be re-injected into the Wells with the objective of an 18% reduction in Oil to Sea. This objective was achieved with the installation of 2 new Booster Pumps located on a new Platform at ESDV Level. A new De-Sanding Package was located on a new Deck Extension at the NE Face of the Platform. |
 |
The Otter Field is located in the UK Northern North Sea and was developed via a subsea tie back to the existing Shell Eider Platform. From Eider, oil and gas from Otter is exported via the North Cormorant to Sullom Voe and St. Fergus. |
 |
The Penguins Field is located in the UK Northern North Sea, some 150km north-east of the Shetland Islands. It has been developed as a subsea cluster and is tied back to the existing Brent Charlie platform. The Penguins field is tied-bac via a single 16-inch diameter production pipeline to the Brent Charlie Platform, which at 65km created the longest sub-sea tie-back in the UKCS. The oil produced by Penguins is exported from Brent, via the Cormorant to Sullom Voe, and gas via the Brent system to St. Fergus. |
 |
The Penguin Field is located in Blocks 211/13a and 211/14 of the North Sea, and is tied back to the Brent C Platform via a pipe-in-pipe Production Pipeline and Control Umbilical. Provision was made in the Penguin design for future Gas Lift to the Penguin Drill Centre. New Topside and Subsea Gas Lift Facilities were provided to supply Lift Gas to the Penguins Field. A 4 diameter Gas Lift Pipeline was laid alongside the 66.7km Production Pipeline and tied back to the Brent C Topsides. Lift Gas is sourced upstream of the BC Export Gas Backpressure Valve. |
 If you are active in Brazil or looking to establish new markets in the latest more
|
 These images were provided to illustrate the general layout and location of a more
|
 This presentation contains information about the Dunlin A Platform. The more
|
|
I have recently moved all Client Download files to this server, available from more
|
 This work comprised an engineering study investigating the operational issues more
|
The Dunbar field, situated 22km south of Alwyn North, first produced oil/gas more
|
 This presentation describes the replacement and bypass of the Cell more
|
 The Starling well fluids are brought onboard Shearwater 'A' Platform through a more
|
|
The Simian/Sienna and Sapphire Fields are located off the coast of Egypt in the more |
